The Ports; Figure 3-2: Back View - Linksys SRW224P - 10/100 - Gigabit Switch User Manual

Wireless-G Access Point with Power Over Ethernet and Rangebooster

The Ports

The Access Point's port are located on the back of the device.
Reset Button There are two ways to reset the Access Point to the factory default configuration. Either press
the Reset button, for approximately ten seconds, or restore the defaults using the Access
Point's web-based utility.
Ethernet The Ethernet network port connects to Ethernet network devices, such as a switch or router
that may or may not support Power over Ethernet (PoE).
Power The Power port connects to the supplied power adapter.
Chapter 3: Getting to Know the Wireless-G Access Point
The Ports

Figure 3-2: Back View

port: the connection point on a computer or
networking device used for plugging in
cables or adapters
IMPORTANT: Resetting the Access Point will
erase all of your settings (including wireless
security, IP address, and SSID) and replace
them with the factory defaults. Do not reset
the Access Point if you want to retain these
settings.
8