Resolving Volume Mounting Problems Because Of Name Space Module - Novell NETWARE 6-DOCUMENTATION Manual

Resolving Volume Mounting Problems Because of
Name Space Module
48
Traditional File Services Administration Guide
A power failure has occurred and the server has not been shut down with
the DOWN command.
A hard disk has failed.
A disk channel error has occurred.
A volume does not dismount when you enter the DISMOUNT command.
Directory information in cache is not completely written to disk.
To resolve problems when mismatches exist in the duplicate copies of the FAT
and DET, do the following:
Run VREPAIR.
Add a UPS system so that the server is shut down automatically when a
power failure occurs.
Replace faulty disks or controllers.
After a volume has been configured to support more than the DOS naming
convention, the name space NLM program must be loaded before the volume
can be mounted.
To diagnose problems when a traditional volume cannot mount because the
name space NLM program is not loaded, identify whether the following
conditions exist:
The command to load the name space NLM is not in the STARTUP.NCF
file.
The NLM to load the name space has not been copied to the boot
directory of the server.
To resolve problems when a traditional volume cannot mount because the
name space NLM program is not loaded, do the following:
Load the name space NLM program and then mount the volume. Copy
the name space NLM to the server boot directory and add the LOAD
command to the STARTUP.NCF file. The NLM then loads automatically
whenever the server is booted.
Delete the name space configuration from the volume.