Starting The Service - Novell ZENWORKS ENDPOINT SECURITY MANAGEMENT 3.5 Installation Manual

6 At the Copy Files screen, click Next to begin the installation.
7 Specify the file paths for the data, index, and log files.
8 An
ESM Setup Files
file and the
ID
the Management Service. Use Browse to designate where this file should be saved on the server
(default = installation directory).
Figure 5-9
9 If you chose to use an enterprise SSL certificate, place a copy of this file into the
Files
10 Copy the entire
Management Service, either via a netshare or by saving the file to a disk or thumb drive and
hand-loading it into the server installation directory.
11 The Policy Distribution Service is now installed, click Finish to close the installation program
to launch the performance monitor.

5.2 Starting the Service

The Policy Distribution Service launches immediately following installation, with no reboot of the
server required. The Management Console is used to adjust upload times for the Distribution Service
using the Configuration tool. For more information, see the
Management Administration
Continue with
32 ZENworks Endpoint Security Management Installation Guide
folder is generated in the installation directory. This contains a
file (Novell self-signing SSL certificate, if selected) required by
ESM-DS.cer
Save Setup Files
folder.
ESM Setup Files
Guide.
Chapter 6, "Performing the Management Service Installation," on page
directly onto the machine designated as the host for the
ZENworks Endpoint Security
Setup
ESM Setup
33.