Command Line Variables - Novell ZENWORKS ENDPOINT SECURITY MANAGEMENT 3.5 Installation Manual

8 Click Install to create the MSI image. Click Finish to close the setup program.
9 Browse to the location where you created the MSI image and open the
Files\Novell ZENworks\Endpoint Security Client\
10 Copy the Management Service SSL certificate (
the Novell license key into this folder, replacing the default 0 KB files currently in the folder.
The ESM-MS SSL certificate is available in the
Management Setup Files
60-day evaluation, no license key is necessary at this time.

9.2.4 Command Line Variables

Command Line variable options are available for an MSI installation. These variables must be set in
the executable shortcut that is set to run in administrator mode. To use a variable, the following
command line must be entered in the MSI shortcut:
"...\setup.exe" /a /V"variables"
marks. Separate multiple variables with a single space.
The following command line variables are available:
Command Line Variables
Table 9-1
Command Line Variable
/qn
SESMSG=1
68 ZENworks Endpoint Security Management Installation Guide
folder. The license key is e-mailed separately. If you are using the
. Enter any of the commands below between the quotation
Description
Quiet install.
Shows a message to the end user
that files in "Safe Harbors" cannot
automatically have encryption
removed if an Encryption Policy is
deployed.
\Program
folder.
, or the enterprise certificate) and
ESM-MS.cer
ZENworks Endpoint Security
Notes
Suppresses the typical MSI
Installation process. The Endpoint
Security Client will activate at the next
user reboot.
The default value is 0 (don't display
messages) in order to make the
uninstall "silent."