Upgrading From Zenworks Configuration Management 10.1.X To Sp3 (10.3); Understanding What The Upgrade Does Not Do; Upgrading To Zenworks Configuration Management 10.3 - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT - UPGRADE GUIDE 10.3 30-03-2010 Upgrade Manual

Upgrading from ZENworks
3
Configuration Management 10.1.x
to SP3 (10.3)
This section contains information about upgrading from Novell
Management 10.1.x to ZENworks Configuration Management SP3 (10.3). For information about
upgrading from ZENworks Configuration Management 10.0.x, see
ZENworks Configuration Management 10.0.x to SP3 (10.3)," on page
To upgrade from Novell ZENworks 10 Configuration Management 10.1.x to ZENworks 10
Configuration Management SP3 (10.3), devices must meet the requirements described in
Requirements" in the ZENworks 10 Configuration Management Installation
Because of changes in the ZENworks architecture, ZENworks servers and managed devices cannot
be upgraded from version 10.1.x directly to version 10.3. However, you can use a combination of
ZENworks System Update and the installation media to go from 10.1.x to 10.3.
You cannot use the ZENworks 10 Configuration Management SP3 installation media to upgrade
from version 10.1.x to SP3. You must follow the directions in this section.
Perform the tasks in the following sections to upgrade to ZENworks 10 Configuration Management
SP3:
Section 3.1, "Understanding What the Upgrade Does Not Do," on page 21
Section 3.2, "Upgrading to ZENworks Configuration Management 10.3," on page 21
Section 3.3, "Post-Upgrade Tasks," on page 22
3.1 Understanding What the Upgrade Does Not
Do
You cannot migrate the custom reports created in ZENworks 10 Configuration Management with
SP1 (10.1) to ZENworks 10 Configuration Management with SP3 (10.3). You must re-create these
reports on the ZENworks Reporting Server.
3.2 Upgrading to ZENworks Configuration
Management 10.3
1 Make sure that you have completed the steps in
BusinessObjects Enterprise Server," on page
2 Use System Update to upgrade ZENworks Servers and managed devices from ZENworks
Configuration Management 10.1.x to 10.2.
The ZENworks 10 Configuration Management SP2 (10.2) update is cumulative, meaning that
you can upgrade Primary Servers and managed devices directly to version 10.2 from the
following versions:
ZENworks 10 Configuration Management SP1 (10.1)
Section 2.1, "Pre-Upgrade Tasks for
15.

Upgrading from ZENworks Configuration Management 10.1.x to SP3 (10.3)

® ®
ZENworks Configuration
Chapter 2, "Upgrading from
15.
Guide.
3
"System
21