Table of Contents
Advertisement
6.8
D
EPLOYING VIRTUAL APPLICATIONS TO
M
ANAGEMENT
This section describes ZENworks Application Virtualization Startup and Bundle Publishing
features. All options described in this section can be found in the ZENworks panel.
6.8.1 ZENworks Startup
Virtual applications built with ZENworks Application Virtualization can be configured to require
the ZENworks Configuration Management Agent to be installed on the host device executing the
virtual application. By default, virtual applications built with ZENworks Application
Virtualization do not require the ZENworks Configuration Management Agent.
To require the ZENworks Configuration Management Agent to be installed on the host system,
check the Require ZENworks Configuration Management Agent to be installed on
workstation executing the virtual application checkbox in the ZENworks panel.
When virtual applications built with ZENworks Application Virtualization require the ZENworks
Configuration Management Agent to be installed, they can also be configured to restrict execution
to a specific ZENworks Configuration Management Zone.
To restrict virtual application execution to a specific ZENworks Configuration Management Zone,
check the Only allow devices registered in specific zone to execute the application checkbox in
the ZENworks panel. When prompted, enter the ZENworks Server Address, click Connect,
enter the appropriate Username and Password, and click OK.
When specifying the ZENworks Server Address, it is necessary to use the secure HTTP prefix
(https://) in order to connect to a secure ZENworks Configuration Management Server.
When specifying the ZENworks Server Address, you must also use a port number suffix
(e.g.:81) if the ZENworks Configuration Management Server has been configured to use a custom
port number.
6.8.2 ZENworks Bundle Publishing
ZENworks Application Virtualization can publish virtual application bundles directly to a
ZENworks Configuration Management Zone. Note that if a virtual application has been built with
ZENworks Configuration Management Zone restriction, the application will not execute on
devices outside of the restricted zone.
To manually publish a virtual application bundle directly to a ZENworks Configuration
Management Zone:
•
Select MSI or Executable for the Project Type. The MSI or Executable must be built
before publication can occur.
•
Click Select Zone under the ZENworks Bundle Publishing pane.
•
When prompted, enter the ZENworks Server Address and click Connect.
•
Log in to the ZENworks Server with the appropriate Username and Password and click
OK.
62
ZEN
C
WORKS
ONFIGURATION
Novell ZENworks Application Virtualization
Advertisement
Table of Contents
