Reinstalling The Novell File Upload Extension; Uploading Waik; Installing Sysinfo - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT - UPGRADE GUIDE 10.3 30-03-2010 Upgrade Manual

For more information on how to decommission ZENworks Reporting Server, see
"Decommissioning an Existing Instance of ZENworks Reporting
Configuration Management Reporting Server Installation
2 (Optional) After the new installation of ZENworks Reporting Server installation is complete,
uninstall the earlier instance of ZENworks Reporting Server (that you decommissioned) from
the former Primary Server.
For more information on how to uninstall ZENworks Reporting Server, see the
ZENworks Reporting
Server Installation Guide.

4.2.2 Reinstalling the Novell File Upload Extension

If the ZENworks 10 Configuration Management File Upload extension is already installed on the
server that is running ZENworks Control Center, you must reinstall the Novell File Upload
Extension before performing any third-party Imaging operations. For detailed information on how to
reinstall the Novell File Upload Extension, see
Extension," on page 29

4.2.3 Uploading WAIK

If you are upgrading from ZENworks 10 Configuration Management SP2 (10.2) to ZENworks 10
Configuration Management SP3, and if WAIK was already uploaded prior to the upgrade, you must
upload WAIK (
winpe.wim
SP2. For more information on how to upload WAIK, see the
Management Preboot Services and Imaging

4.2.4 Installing Sysinfo

If you upgrade the Primary Server from ZENworks 10 Configuration Management SP2 (10.2.x) to
ZENworks 10 Configuration Management SP3, you must install Sysinfo that is packaged with the
Inventory-Only module on the existing Linux*, HP-UX*, AIX*, and Solaris* inventory-only
devices.
To install Sysinfo, perform the following tasks on the inventory-only device:
1 Uninstall the existing version of Sysinfo by running the following command:
/opt/novell/zenworks/sysinfo/setup --uninstall --confirm
2 Depending upon the inventory-only device platform, download the appropriate Inventory-Only
module ( ) from the ZENworks Server.
.tar
For more information on how to download the Inventory-Only module from the ZENworks
Server, see "Downloading the Module from a ZENworks
Configuration Management Discovery, Deployment, and Retirement
3 Extract the
inventory-only_package.tar
inventory-only_package.tar
directory on a Linux device.
The
inventory-only_package.tar
Inventory-Only module package.
mcsysinfo-noui-9-H12-linux-x86.sh
Server" in the ZENworks 10 Configuration Management Reporting
Appendix A, "Reinstalling the Novell File Upload
) again after upgrading to ZENworks 10 Configuration Management
Reference.
file to a temporary location. Assume that the
file is extracted to the
file includes the Sysinfo installer specific to the
Upgrading from ZENworks Configuration Management 10.2.x to SP3 (10.3)
Server" in the
Guide.
ZENworks 10 Configuration
Server" in the ZENworks 10
Reference.
/opt/novell/zenworks/tmp
(for Linux)
ZENworks 10
"Uninstalling
27