Cifs; Changing The Server Ip Address; Consoleone Can Cause Jclient Errors; Cups On Oes 2 - Novell OPEN ENTERPRISE SERVER - PLANNING AND IMPLEMENTATION GUIDE 12-2010 Implementation Manual

NOTE: The list of users and groups in
SP3," on page 259
Create Only eDirectory Users and Groups
For OES 2 services, the LUM technology eliminates the need for local users and groups. We
recommend, therefore, that you avoid the problems discussed in this section by not creating local
users and groups.

6.3 CIFS


Section 6.3.1, "Changing the Server IP Address," on page 62

6.3.1 Changing the Server IP Address

Reconfiguring CIFS in YaST might not take effect if the server IP address was changed on the server
but not in the OES LDAP server configuration.
To work around this:
1 Reconfigure the LDAP server IP address with the IP address changes.
2 Then change the CIFS IP address configuration.

6.4 ConsoleOne Can Cause JClient Errors

ConsoleOne support is now limited to management of GroupWise and ZENworks for Desktops 7.
If you need to use ConsoleOne to manage either of these supported products on OES 2, make sure
you have installed version 1.3.6h or later.
Earlier versions of ConsoleOne cause JClient errors in iManager.

6.5 CUPS on OES 2

iPrint is the print solution for OES 2 and offers more robust and scalable print services than a CUPS
installation can. iPrint actually uses CUPS to render print jobs prior to sending them to the printer,
but for scalability and performance, printing from the server itself is disabled during iPrint
installation.
If you plan to use iPrint, deselect Print Server in the Primary Functions category during the install
and don't configure CUPS on the OES 2 server.
6.6 DSfW: MMC Password Management
Limitation
After creating a user, you cannot then force a password change through the Microsoft Management
Console (MMC) because the User must change password at next logon option is disabled. You can
work around this issue while creating the user by selecting the option as part of the creation task. For
existing users, you can reset the password and select the same option as part of the reset task.
62 OES 2 SP3: Planning and Implementation Guide
Appendix I, "System User and Group Management in OES 2
is not exhaustive. For example, the group is not listed.
users