Novell OPEN ENTERPRISE SERVER - PLANNING AND IMPLEMENTATION GUIDE 12-2010 Implementation Manual page 257

Services Associated with Scripts
Novell Remote Manager
Novell Storage Services
Novell Remote Manager e-mail
notifications
NTP
OpenWBEM CIMOM
Patching
Red Carpet
Samba
Samba CIFS support
SLP support
Storage Management Services
Tomcat
Script Name Notes
novell-httpstkd This script runs by default on every OES 2
server and enables access to NRM for
Linux through a browser.
Use this script followed by the status option
to view current status. Or use stop, start, or
restart options to alter the run state of the
NRM daemon as needed.
novell-nss This script runs by default on every OES 2
server with NSS volumes and enables
access to the NSS runtime environment.
To see if the NSS kernel modules and NSS
admin volume are running, enter
novell-nss status
novell-nss status
status
not running, use the
them. You cannot stop NSS.
postfix Novell Remote Manager uses this to send
notifications as configured.
ntp This is the SLES 10 Network Time Protocol
daemon.
This is used to start the OpenWBEM
owcimomd
CIMOM daemon, which is an integral part
of the iManager plug-ins for LUM, Samba,
NSS, SMS, and NCS. iPrint and NRM also
use OpenWBEM.
Novell Remote Manager on OES 2 gets its
server health information from CIMOM.
novell-zmd This is the GUI patch updater daemon.
rcd This is the rug command line daemon.
nmb This is the Samba NetBIOS naming
daemon.
smb This script runs the Samba daemon.
slpd This lets you start and stop OpenSLP,
which is a key component for eDirectory
and certain other services and clients.
novell-smdrd This lets you start and stop the SMDR
daemon precess. It also loads and unloads
the NSS zapi kernel module used by SMS
to back up the NSS volumes.
novell-tomcat5 This script sets up the SLES 10 Tomcat
specifically for OES 2 services, such as the
Welcome pages.
service
,
/etc/init.d/
, or
rcnovell-nss
at a command prompt. If they are
option to start
start
OES 2 Service Scripts 257