Novell OPEN ENTERPRISE SERVER - PLANNING AND IMPLEMENTATION GUIDE 12-2010 Implementation Manual page 115

5b In the left navigation frame, click Allowed Services.
5c Click the Services to Allow drop-down list and select SLP Daemon.
5d Click Add > Next.
5e Click Accept.
6 At the command prompt, enter the following command to restart the SLP daemon:
rcslpd restart
7 (Conditional) If you are doing this after installing OES 2 and eDirectory, you must also restart
eDirectory by entering the following command:
rcndsd restart
8 Continue with the following sections that apply to your situation:

Configuring OES 2 Servers to Access the OpenSLP DA (page 115)

Configuring NetWare Servers to Use the OpenSLP Service (page 116)
Configuring OES 2 Servers to Access the OpenSLP DA
If you created the OpenSLP DA on an OES 2 server installed in your tree, then SLP is properly
configured on that server and these instructions do not apply to it.
For all other OES 2 servers installed in your eDirectory tree, you should complete one of the
following procedures as it applies to your situation:

"Configuring for DA Access During the OES 2 Installation" on page 115

"Configuring for DA Access Before or After Installing the OES 2 Server" on page 116
Configuring for DA Access During the OES 2 Installation
As you install OES 2 by using the instructions in the
OES 2 SP3: Installation Guide, do the following:
1 When you reach the SLP section of the installation, select Configure SLP to Use an Existing
Directory Agent.
The first option, Do not configure SLP, causes problems with eDirectory and other services if
this is the fourth or later server installed in the tree. The second option, Use Multicast, requires
that you disable the firewall on the server. Disabling the firewall is always discouraged.
2 In the Service Location Protocol Scopes field, specify the scope you defined in
page 114. You can also list additional scopes, separated by commas (no spaces).
For example, you might type
the DA you created.
3 In the Configured SLP Directory Agent field, type the IP address of the DA server you defined
in "Setting Up an OpenSLP DA Server" on page
addresses, separated by commas.
4 Return to the
"Novell eDirectory
"Novell eDirectory
in the field if that is the scope name you assigned to
Directory
114. You can also list additional DA
Services" instructions in the
Services" section of the
Step 4 on
OES 2 SP3: Installation Guide.
Network Services 115