Language; Ibm System Z: Hard Disk Configuration - Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 08-05-2008 Installation Manual

smtcert has been entered, you will be prompted for a local path to the certifi-
cate.
In case smtcert is not specified, it will default to http://FQN/smt.crt with
FQN being the name of the SMT server.

3.6 Language

YaST and SUSE Linux Enterprise in general can be configured to use different languages
according to your needs. The language selected here is also used for the keyboard layout.
In addition, YaST uses the language setting to guess a time zone for the system clock.
These settings can be modified later along with the selection of secondary languages
to install on your system.
You can change the language later during installation as described in
"Installation Settings"
system, see
3.7 IBM System z: Hard Disk
When installing on IBM System z platforms, the language selection dialog is followed
by a dialog to configure the attached hard disks. Select DASD, Fibre Channel Attached
SCSI Disks (ZFCP), or iSCSI for installation of SUSE Linux Enterprise.
After selecting Configure DASD Disks, an overview lists all available DASDs. To get
a clearer picture of the available devices, use the entry field located above the list to
specify a range of channels to display. To filter the list according to such a range, select
Filter. See
24 Installation and Administration
(page 29). For information about language settings in the installed
Section 8.1, "YaST Language"
Configuration
Figure 3.1, "IBM System z: Selecting a DASD"
(page 130).
(page 25).
Section 3.12,