Diamondback 1260Ef Owner's Manual page 28

1260OM 5/31/06 7:11 PM Page 30
26
Workout Programs (continued)
If the entry reaches 85% of Max HR, the message display will flash
a message of "HR = 85 PERCENT" to indicate that the adjustment
is at its maximum.
3. After HR adjustment, the message display will switch to display
"SET UP COMPLETED", then flashes " PRESS START" to indicate
next step. You may press, "Start" to begin this program. (Note: you
may press Start key anytime to skip the setup and begin the
workout immediately.)
During the Program
Once Start key is pressed, the Warm Up will be active. See Warm Up mode section for
details.
Display
• When warm up mode is completed, the console will detect if there is a valid
pulse before starting this problem.
– If there is none, this program will not be started. The messages display
will scroll " NO VALID PULSE", and "CHECK YOUR PULSE SENSOR" until
there is valid pulse.
– If there is a valid pulse, this program will be active. The message display
will turn into workout data display and display four default data: time, %
Max HR, calories & pulse.
• Press "Select" button under each group to select your desired data display.
Adjustment
• Press "Level Up/Down" key to adjust the Target HR. The dot matrix window
will update the % Max HR profile accordingly.
• Press "Incline Up/Down" key to adjust the incline level from L1 to L10. The
dot matrix window will update the incline profile accordingly.
• Personal Trainer program – Personal Trainer program cannot be active during
Target HR program. See Personal Trainer program section for details.
• HR Lock program – Press "HR Lock" key to switch to a new target HR program
with current HR. See HR Lock program section for details.
Ending the Program
• When program time is up or Stop key is pressed, this program will end and
Cool Down will be active.
• The message display will flash a message "PROGRAM END" & "COOL
DOWN". See Cool Down mode for details.
• "Start" key could be pressed to re-start the Target HR program again.
• "Stop" key could be pressed to skip the cool down and active the Workout
Summary immediately.
Pause, Reset, Switch or Save a program
See Console Operating Tips section for details, pages 9 & 10.
1260Ef Owner's Manual