C H A P T E R 5 Monitoring And Troubleshooting Wideband Components; Monitoring Wideband Sips; Show Diag - Cisco WCM300 - Channel Bonded Cable Modem Implementation Manual

Monitoring Wideband Components
Table 5-1
Document
Cisco Broadband Cable Command Reference
Guide
Cisco IOS Release 12.3 Commands Master
Commands List

Monitoring Wideband SIPs

The following command is useful for monitoring a Cisco Wideband SIP:
In addition, the show controllers jacket command displays Wideband SIP register values. The show
controllers jacket is intended for use by Cisco Systems technical support personnel.

show diag

To verify that the Wideband SIP is powered on, use the show diag command. If show diag displays any
output, the Wideband SIP is powered on. The show diag command provides a variety of information on
the Wideband SIP. For example, the hardware type of the Wideband SIP is 2jacket-1 card.
Router# show diag 1/0
Slot/Subslot 1/0:
EEPROM contents, slot 1/0:
...
If show diag displays no output, the Wideband SIP is not powered on.
Router# show diag 1/0
Router#
Cisco Cable Wideband Solution Design and Implementation Guide, Release 1.0
5-2
Wideband Command Reference Documentation
2jacket-1 card, 0 ports
Card is full slot size
Card is analyzed
Card detected 16:46:44 ago
Card uptime 0 days, 16 hours, 46 minutes, 36 seconds
Card idle time 0 days, 14 hours, 22 minutes, 34 seconds
Voltage status: 3.3V Nominal 2.5V Nominal 1.5V Nominal 12V Nominal
Hardware Revision
Top Assy. Part Number
Board Revision
Deviation Number
Fab Version
PCB Serial Number
RMA Test History
RMA Number
RMA History
CLEI Code
// Displays no output
Chapter 5 Monitoring and Troubleshooting Wideband Components
Command Described
Commands for cable modems and wideband-cable
interfaces (wideband channels)
Commands for IOS Release 12.3 that are not
cable-specific
: 1.0
: 800-22843-04
: 01
: 0-0
: 04
: CSJ09030613
: 00
: 0-0-0-0
: 00
:
show diag.
OL-10705-02