Table of Contents
Advertisement
Monitoring and Troubleshooting Wideband
Components
This chapter provides an introduction to monitoring and troubleshooting the wideband components of
the Cisco Cable Wideband Solution, Release 1.0. The chapter includes the following topics:
•
•
Monitoring Wideband Components
The Cisco IOS command-line interface includes commands that can be issued on the CMTS for the
following:
•
•
•
•
•
For detailed information on the syntax, usage, and additional examples for each command, see the
documents shown in
Many of the commands used to configure the Cisco uBR10012 router and the Cisco Wideband SIP and
Note
SPA are not currently part of the command set that can be searched with the Cisco Command Lookup
Tool (available on Cisco.com). Use the documents listed in
commands.
Table 5-1
Document
Cisco uBR10012 Universal Broadband Router
SIP and SPA Software Configuration Guide
OL-10705-02
Monitoring Wideband Components, page 5-1
Troubleshooting Wideband Components, page 5-13
Monitoring Wideband SIPs, page 5-2
Monitoring Wideband SPAs, page 5-3
Monitoring Wideband Channels, page 5-6
Monitoring RF Channels, page 5-10
Monitoring Wideband Cable Modems, page 5-10
Table
5-1.
Wideband Command Reference Documentation
Cisco Cable Wideband Solution Design and Implementation Guide, Release 1.0
C H A P T E R
Table 5-1
to find information on these
Command Described
Commands for the Wideband SIP and Wideband
SPA, including commands for RF and wideband
channels
5
5-1
Advertisement
Table of Contents
Troubleshooting
