Monitoring Wideband Channels; Show Interface Wideband-Cable - Cisco WCM300 - Channel Bonded Cable Modem Implementation Manual

Monitoring Wideband Components
Phased Initialization
...

Monitoring Wideband Channels

The following commands are useful for monitoring wideband channels:
•
•

show interface wideband-cable

To display information about a wideband-cable interface (wideband channel), use the show interface
wideband-cable command. Wideband channels are similar to cable interfaces and information about
them is also displayed with the show ip interfaces and show interfaces commands.
Cisco Cable Wideband Solution Design and Implementation Guide, Release 1.0
5-6
Bit Rate: 1300 Mbps
50 micron-multimode fiber supported length: 550 m
62.5 micron-multimode fiber supported length: 270 m
Upper bit rate limit: not specified
Lower bit rate limit: not specified
Date code (yy/mm/dd): 05/02/23
Vendor name: CISCO-AGILENT
Vendor OUI: 12499
Vendor Part Number (PN): QFBR-5766LP
Vendor SN (SN): AGS090855CE
Options implemented:
LOS Signal
TX Fault Signal
TX Disable Signal
Enhanced options implemented: none
Diagnostic monitoring implemented: none
Idprom contents (hex):
0x00: 03 04 07 00 00 00 01 00 00 00 00 01 0D 00 00 00
0x10: 37 1B 00 00 43 49 53 43 4F 2D 41 47 49 4C 45 4E
0x20: 54 20 20 20 00 00 30 D3 51 46 42 52 2D 35 37 36
0x30: 36 4C 50 20 20 20 20 20 20 20 20 20 03 52 00 B5
0x40: 00 1A 00 00 41 47 53 30 39 30 38 35 35 43 45 20
0x50: 20 20 20 20 30 35 30 32 32 33 20 20 00 00 00 C4
0x60: 00 00 06 C9 F0 FA 7C 01 B3 C8 41 6B 39 04 FC 85
0x70: BB 20 9E 00 00 00 00 00 00 00 00 00 B4 94 52 CC
0x80: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x90: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
State: Initalized
Phase Reached: 4
Phase Exit Code: 0
Phase Read Offset: 0
show interface wideband-cable
show hw-module bay
Chapter 5 Monitoring and Troubleshooting Wideband Components
Vendor Rev:
OL-10705-02