Wake Up Events - JETWAY V880DASR2A User Manual

Video Off Method
This determines the manner in which the monitor is blanked.
DPMS (default)
Blank Screen
V/H SYNC+Blank
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
Power Button Function
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off
state. The settings are: Delay 4 Sec, Instant-Off.
State After Power Failure
This item allows the system power ON/OFF automatic when power loss and recovery again,
you can choose Auto for recovery pre-state, or always ON/OFF after power recovery.

Wake Up Events

Please refer to section 3-8-1
3-8-1 Wake up Events
CMOS Setup Utility – Copyright(C) 1984-2004 Award Software
VGA
LPT & COM
HDD & FDD
PCI Master
Wake-Up on LAN/Ring
Wake-Up on PCI PME
Wake-Up On Hot Key (PS2 KB)
RTC Alarm Resume
x Date of Month Alarm
x Time (hh:mm:ss) Alarm
> IRQs Activities
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Wake Up On Ring/PME
During Disabled, the system will ignore any incoming call from the modem. During
Enabled, the system will boot up if there's an incoming call from the modem.
Initial display power management signaling.
This option only writes blanks to the video buffer.
This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video
buffer.
Wake Up Events
OFF
LPT/COM
ON
OFF
Disabled
Disabled
Disabled
Disabled
0
0 : 0 : 0
Press Enter
F6:Optimized Defaults
34
Item Help
Menu Level >>
F7:Standard Defaults