JETWAY V880DASR2A User Manual page 19

(7) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to the floppy drives.
(8) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s).
If you install two hard disks, you must configure the second drive to Slave mode by
setting its jumpers accordingly. Please refer to the documentation of your hard disk for
the jumper settings.
(9) Secondary IDE Connector (40-pin block): IDE2
This connector connects to the next set of Master and Slave hard disks. Follow the
same procedure described for the primary IDE connector. You may also configure
two hard disks to be both Masters using one ribbon cable on the primary IDE connector
and another ribbon cable on the secondary IDE connector.
PS/2
Mouse
PS/2
Keyboard
FDD
Pin 1
Floppy Drive Connector
IDE1
Pin 1
Primary IDE Connector
14
LAN
COM1 USB1
USB
MIC
LINE-IN
LINE-OUT