Wake Up Events; 3-8-1.1 Irqs Activities - JETWAY PM800DM User Manual

Power Button Function
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off state.
The settings are: Delay 4 Sec, Instant-Off.
State After Power Failure
This item allows the system power ON/OFF automatic when power loss and recovery again, you
can choose Auto for recovery pre-state, or always ON/OFF after power recovery.

Wake Up Events

Please refer to section 3-8-1
3-8-1 Wake up Events
CMOS Setup Utility – Copyright(C) 1984-2004 Award Software
VGA
LPT & COM
HDD & FDD
PCI Master
Wake-Up on Ring/LAN
Wake-Up on PCI PME
PS2 KB Wakeup Selection
Wake-Up on Hot Key (PS KB)
Wake-Up on RTC Alarm
x Date of Month Alarm
x Time (hh:mm:ss) Alarm
> IRQs Activities
(((( Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
Wake Up On Ring/PME
During Disabled, the system will ignore any incoming call from the modem. During Enabled, the
system will boot up if there's an incoming call from the modem.
Wake-Up on RTC Alarm
This function is for setting date and time for your computer to boot up. During Disabled, you
cannot use this function. During Enabled, choose the Date and Time Alarm:
Date(of month) Alarm
You can choose which month the system will boot up. Set to 0, to boot every day.
Time(hh:mm:ss) Alarm
You can choose what hour, minute and second the system will boot up.
IRQs Activities
Please refer to section 3-8-1.1
3-8-1.1 IRQs Activities
CMOS Setup Utility – Copyright(C) 1984-2004 Award Software
Primary INTR
IRQ3 (COM 2)
Wake Up Events
OFF
LPT/COM
ON
OFF
Disabled
Disabled
Hot Key
Disabled
Disabled
0
0 : 0 : 0
Press Enter
F6:Optimized Defaults
IRQs Activities
ON
Enabled
32
Item Help
Menu Level >>
F7:Standard Defaults
Item Help