Pm Timer Reload Events - JETWAY I401R5A User Manual

This determines the manner in which the monitor is blanked. The choice are Yes → Video
will off , and No→ Video always On.
Video Off Method
This determines the manner in which the monitor is blanked.
DPMS (default)
Blank Screen
V/H SYNC+Blank This selection will cause the system to turn off the vertical and
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
Power Button Function
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off
state. The settings are: Delay 4 Sec, Instant-Off.
Wake-Up by PCI card /Power On by Ring
During Disabled, the system will ignore any incoming call from the PCI card/modem.
During Enabled, the system will boot up if there's an incoming call from the PCI card
/modem.
Wake-Up on RTC Alarm
This function is for setting date and time for your computer to boot up. During Disabled,
you cannot use this function. During Enabled, choose the Date and Time Alarm:
Date(of month) Alarm
You can choose which month the system will boot up. Set to 0, to boot every day.
Time(hh:mm:ss) Alarm
You can choose what hour, minute and second the system will boot up.
Note: If you have change the setting, you must let the system boot up until it
goes to the operating system, before this function will work

PM Timer Reload Events

Please refer to section 3-8-1
3-8-1 PM Timer Reload Events
Initial display power management signaling.
This option only writes blanks to the video buffer.
horizontal synchronization ports and write blanks to the video
buffer.
35