JETWAY I401R5A User Manual page 20

(11) Secondary IDE Connector (40-pin block): IDE2
This connector connects to the next set of Master and Slave hard disks. Follow the
same procedure described for the primary IDE connector. You may also configure
two hard disks to be both Masters using one ribbon cable on the primary IDE
connector and another ribbon cable on the secondary IDE connector.
•
Two hard disks can be connected to each connector. The first HDD is referred to as
the "Master" and the second HDD is referred to as the "Slave".
•
For performance issues, we strongly suggest you don't install a CD-ROM or DVD-
ROM drive on the same IDE channel as a hard disk. Otherwise, the system performance
on this channel may drop.
(12) IDE RAID Connectors : IDE3/IDE4 (Only for I401-R)
When JP14 setting 1-2 closed IDE3/IDE4 are setting in ATA 100 Mode for Normal
extra IDE Interface. When JP14 setting 2-3 closed IDE3/IDE4 can setting RAID
Mode for stripping capable to increase transfer rate, or RAID 1 Mode for mirroring
capable for data protection. For more detail description please read PROMISE.DOC
in CD-PACK X:\MANUAL\PROMISE.DOC file.
Pin 1
Primary IDE Connector
Pin 1
Secondary IDE Connector
17