Pm Timer Reload Events; Pnp/Pci Configuration Setup - JETWAY P4845DDA User Manual

3-8-1 PM Timer Reload Events

CMOS Setup Utility – Copyright(C) 1984-2002 Award Software
Primary IDE 0
Primary IDE 1
Secondary IDE 0
Secondary IDE 1
FDD, COM, LPT Port
PCI PIRQ [A-D] #
↑ ↓ → ← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values

3-9 PnP/PCI Configuration Setup

This section describes configuring the PCI bus system. PCI, or Personal Computer
Interconnect, is a system which allows I/O devices to operate at speeds nearing the speed the
CPU itself uses when communicating with its own special components. This section covers
some very technical items and it is strongly recommended that only experienced users should
make any changes to the default settings.
CMOS Setup Utility – Copyright(C) 1984-2002 Award Software
Reset Configuration Data
Resources Controlled By
x IRQ Resources
PCI/VGA Palette Snoop
Assign IRQ For VGA
↑ ↓ → ← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Reset Configuration Data
Normally, you leave this field Disabled. Select Enabled to reset Extended System Configuration
Data (ESCD) when you exit Setup if you have installed a new add-on and the system
reconfiguration has caused such a serious conflict that the operating system can not boot. The
settings are: Enabled and Disabled.
Resource Controlled By
The Award Plug and Play BIOS has the capacity to automatically configure all of the boot
and Plug and Play compatible devices. However, this capability means absolutely nothing
unless you are using a Plug and Play operating system such as Windows
this field to "manual" choose specific resources by going into each of the sub menu that
PM Timer Reload Events
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
F6:Optimized Defaults
PnP/PCI Configurations
Disabled
Manual
Press Enter
Disabled
Enabled
F6:Optimized Defaults
32
Item Help
Menu Level >>
F1:General Help
F7:Standard Defaults
Item Help
Menu Level >
F1:General Help
F7:Standard Defaults
®
95/98. If you set