Table of Contents
Advertisement
CMOS Setup Utility – Copyright(C) 1984-2003 Award Software
OnChip Primary PCI IDE
OnChip Secondary PCI IDE
Primary Master
Primary Slave
Secondary Master PIO
Secondary Slave PIO
Primary Master
Primary Slave
Secondary Master UDMA
Secondary Slave UDMA
IDE DMA Transfer Access
IDE 32-bit Transfer Mode
IDE HDD Block Mode
Delay For HDD (Secs)
*** On-Chip Serial ATA Setting ***
On-Chip Serial ATA
x Serial ATA Port0 Mode
Serial ATA Port1 Mode
↑ ↓ →← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values
OnChip IDE Primary/Secondary
The integrated peripheral controller contains an IDE interface with support for two IDE channels.
Select Enabled to activate each channel separately. The settings are: Enabled and Disabled.
Primary/Secondary Master/Slave PIO
The four IDE PIO (Programmed Input/Output) fields let you set a PIO mode (0-4) for each of the
four IDE devices that the onboard IDE interface supports.
successively increased performance. In Auto mode, the system automatically determines the best
mode for each device. The settings are: Auto, Mode 0, Mode 1, Mode 2, Mode 3, Mode 4.
Primary/Secondary Master/Slave UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the
operating environment includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus
master driver). If your hard drive and your system software both support Ultra DMA/33 and
Ultra DMA/66, select Auto to enable BIOS support. The settings are: Auto, Disabled.
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector read/write. If
your IDE hard drive supports block mode (most new drives do), select Enabled for automatic
detection of the optimal number of block read/writes per sector the drive can support. The
settings are: Enabled, Disabled.
On-Chip Serial ATA
Onboard IDE Function
Enabled
Enabled
PIO
Auto
PIO
Auto
Auto
Auto
UDMA
Auto
UDMA
Auto
Auto
Auto
Enabled
Enabled
Enabled
0
Disabled
Primary Master
Primary Master
F6:Optimized Defaults
Menu Level >>
F7:Standard Defaults
Modes 0 through 4 provide
35
Item Help
Advertisement
Table of Contents
