(6)
Speaker connector: SPEAKER
This 4-pin connector connects to the case-mounted speaker. See the figure below.
(7)
Power LED: PWR LED
The Power LED is light on while the system power is on. Connect the Power LED
from the system case to this pin.
(8)
Power switch: PW BN
This 2-pin connector connects to the case-mounted power switch to power ON/OFF the
system.
(9)
Wake On-LAN/Modem Headers (3-pin) : WOL, WOM
This connector connects to a LAN/Modem card with a WAKE ON-LAN/Modem
output. This connector power up the system when a wake up signal is received through
the LAN/Modem card.
NOTE: This feature requires that Wake On LAN or Ring In Wake up is enabled.
(10) FAN Speed Headers (3-pin) : FAN1, FAN2, CPUFAN
These connectors support cooling fans of 350mA (4.2 Watts) or less, depending on the
fan manufacturer, the wire and plug may be different. The red wire should be positive,
while the black should be ground. Connect the fan's plug to the board taking into
consideration the polarity of connector.
VCC
NC
Speaker
GND
Reset SW
GND
Turbo LED
GND
System Case Connections
WOM
1
3
Wake-On-Modem Headers
19
GND
NC
Power LED
VCC
GND
Turbo SW
VCC
WOL
1
3
Wake-On-LAN Headers