Table of Contents
Advertisement
WARNING!
For the DDR SDRAM CLOCK is set at 133MHz, use only PC2100-compliant
DDR Modules. When this motherboard operate at 133Mhz, most system
will not even boot if non-compliant modules are used because of the strict
timing issues, if your DDR Modules are not PC266-compliant, set the DDR
SDRAM clock to 100MHz to ensure system stability.
2-5 Expansion Cards
WARNING!
Turn off your power when adding or removing expansion cards or other
system components. Failure to do so may cause severe damage to both
your motherboard and expansion cards.
2-5-1 Procedure For Expansion Card Installation
1. Read the documentation for your expansion card and make any necessary hardware or
software setting for your expansion card such as jumpers.
2. Remove your computer's cover and the bracket plate on the slot you intend to use.
3. Align the card's connectors and press firmly.
4. Secure the card on the slot with the screen you remove above.
5. Replace the computer system's cover.
6. Set up the BIOS if necessary.
7. Install the necessary software driver for your expansion card.
2-5-2 Assigning IRQs For Expansion Card
Some expansion cards need an IRQ to operate. Generally, an IRQ must exclusively assign
to one use. In a standard design, there are 16 IRQs available but most of them are already
in use.
Standard Interrupt Assignments
IRQ
Priority
0
1
2
3 *
4 *
5 *
6 *
7 *
8
9 *
10 *
11 *
12 *
13
14 *
15 *
* These IRQs are usually available for ISA or PCI devices.
N/A
System Timer
N/A
Keyboard Controller
N/A
Programmable Interrupt
8
Communications Port (COM2)
9
Communications Port (COM1)
6
Sound Card (sometimes LPT2)
11
Floppy Disk Controller
7
Printer Port (LPT1)
N/A
System CMOS/Real Time Clock
10
ACPI Mode when enabled
3
IRQ Holder for PCI Steering
2
IRQ Holder for PCI Steering
4
PS/2 Compatible Mouse Port
N/A
Numeric Data Processor
5
Primary IDE Channel
1
Secondary IDE Channel
Standard function
13
Advertisement
Table of Contents
