JETWAY 815EDA1A User Manual page 34

Min Saving
Max Saving
User Define(default)
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank
Blank Screen
DPMS (default)
Video Off In Suspend
This determines the manner in which the monitor is blanked. The settings are: Yes and No.
Suspend Type
Select the Suspend Type.
The settings are: PWRON Suspend, Stop Grant.
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
Suspend Mode
When enabled and after the set time of system inactivity, all devices except the CPU will be shut off.
The settings are: l/2/4/8/12/20/30/40 Min, 1 Hour, and Disabled.
HDD Power Down
When enabled and after setting time of system inactivity, the hard disk drive will be powered down
while all the other devices remain active.
The settings are: 1/2/3/4/5/6/7/8/9/10/11/12/13/14/15 Min and Disabled.
Soft-Off by PWR-BTTN
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off state. The
settings are: Delay 4 Sec, Instant-Off.
Wake Up by PCI card
This will enable the system to wake up to PCI LAN Card.
The settings are: Enabled and Disabled.
Power On by Ring
During Disabled, the system will ignore any incoming call from the modem. During Enabled, the
system will boot up if there's an incoming call from the modem.
CPU Thermal-Throttling
Select the CPU THRM-Throttling rate. The settings are: 12.5%, 25.0%, 37.5%, 50.0%, 62.5%, 75.0%,
87.5%.
Resume by Alarm
This function is for setting date and time for your computer to boot up. During Disabled, you cannot
use this function. During Enabled, choose the Date and Time Alarm:
Date(of month) Alarm
You can choose which month the system will boot up. Set to 0, to boot every day.
Time(hh:mm:ss) Alarm
You can choose what hour, minute and second the system will boot up.
Note: If you have change the setting, you must let the system boot up until it goes to the
Minimum power management. Suspend Mode=1 hr., and HDD Power
Down=15 min.
Maximum power management. Suspend Mode=1 min., and HDD Power
Down=1 min.
Allows you to set each mode individually. When not disabled, each of the
ranges is from 1 min. to 1hr. except for HDD Power Down that ranges
from 1 min. to 15 min. and disable.
This selection will cause the system to turn off the vertical and horizontal
synchronization ports and write blanks to the video buffer.
This option only writes blanks to the video buffer.
Initial display power management signaling.
32