Overclock Running; Install Memory - JETWAY 601CFR4A User Manual

has a corner pin for two of the four corners, the CPU will only fit in the orientation as
shown.
When you put the CPU into the ZIF socket. No forces require to insert of the CPU,
then press the level to locate position slightly without any extra force.
2-3-4 Over clock Running
WARNING! This section is for experienced motherboard installer only. Over
clocking can result in system instability or even shortening life of the
processor.
After setting the Jumper JMP1 you can choose over clock running by BIOS CMOS
SETUP UTILITY. When you entered CMOS SETUP UTILITY, choose "Miscellaneous
Control" you will see the screen as below then.
You can choose the situation you want to try.
CMOS Setup Utility – Copyright(C) 1984-2001 Award Software
CyrixIII Clock Ratio
Auto Detect DIMM/PCI Clock
Spread Spectrum
** Current Host Clock is 66MHz **
Host Clock at Next Boot is [66MHz/33MHz]
** Current DRAM Clock is 66Mhz **
DRAM Clock at Next Boot is [66]MHz
:Move Enter:Select
¡ ü ¡ ý ¡ ú ¡ û
F5:Previous Values
In "Host Clock at Next Boot is" item you can step by step change CPU Host Clock to
approach over clocking.

2-4 Install Memory

Colden Arrow
Pentium  III
Miscellaneous Control
Default
Enabled
Disabled
+/-/PU/PD:Value F10:Save
F6:Optimized Defaults
10
Socket 370
CPU ZIF Socket 370
Item Help
Menu Level >
ESC:Exit F1:General Help
F7:Standard Defaults