Table of Contents
Advertisement
2-3-3 Install CPU
This motherboard Provides a ZIF socket 370. The CPU that comes with the motherboard
should have a cooling FAN attached to prevent overheating. If this is not the case, then
purchase a correct cooling FAN before you turn on your system.
WARNING!
Be sure that there is sufficient air circulation across the processor's
heatsink and CPU cooling FAN is working correctly, otherwise it may
cause the processor and motherboard overheat and damage, you may
install an auxiliary cooling FAN, if necessary.
To install a CPU, first turn off your system and remove its cover. Locate the ZIF socket
and open it by first pulling the level sideways away from the socket then upward to a 90-
degree angle. Insert the CPU with the correct orientation as shown below. The notched
corner should point toward the end of the level. Because the CPU has a corner pin for two
of the four corners, the CPU will only fit in the orientation as shown.
When you put the CPU into the ZIF socket. No forces require to insert of the CPU, then
press the level to locate position slightly without any extra force.
2-3-4 Over clock Running
WARNING!
This section is for experienced motherboard installer only. Over clocking
can result in system instability or even shortening life of the processor.
After setting the Jumper JS1, JS4, JS2, JS3 you can choose over clock running by BIOS
CMOS SETUP UTILITY.
"Frequency/ Voltage control" you will see the screen as below then.
You can choose the situation you want to try.
CPU/SDRAM (MHz)
66/100
100/100
133/100
133/133
* AUTO
Pentium
III
Colden Arrow
CPU ZIF Socket 370
When you entered CMOS SETUP UTILITY, choose
JS4
JS1
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
ON
12
Intel
JS2
JS3
2-3
2-3
1-2
2-3
1-2
1-2
2-3
1-2
1-2
1-2
Advertisement
Table of Contents
