Selecting Options - Asko T711 Use And Care Manual

Timed Dry and Air Fluff
When you select Timed Dry or Air Fluff on the program
menu, the word "Time" and a number (of minutes) will
flash in the upper right corner of the LCD window. This
indicates you must select a program time (5 to 90 minutes
in 5-minute increments).
1. Press MENU until "Select time" displays.
2. To change the number, simply press an Arrow button
until the length of time you want the program to run
displays.
3. If you only want to use this setting temporarily (for
this one load), press START. When the program
ends it will revert back to the previous setting.
4. If you want to save this setting permanently, press
ENTER again then press START. The program will
retain the change.
When you press START, the time remaining for the
program to run displays in the bottom right-hand corner
of the LCD window, as illustrated below:
The remaining time toggles between the minutes
remaining (e.g., 23) and the hour(s) remaining (e.g., 1h).
The Temperature Menu
This menu lets you select a Normal or Low temperature.
Only the temperatures available for the dry program you
selected will display.
1. Press MENU until "Select temperature" displays.
2. Use the Arrow buttons to toggle between the
Normal and Low temperature settings.
3. If you only want to use this setting temporarily (for
this one load), press START. When the program
ends it will revert back to the previous setting.
4. If you want to save this setting permanently, press
ENTER again then press START. The program will
retain the change.
Page 20
The Delayed Start Program
This program lets you delay starting the dryer for up to
24 hours. This feature is useful in areas where utility
companies offer discount rates during off-peak hours.
When you select Delayed Start on the program menu,
you must select a delay time (1 to 24 hours).
1. Press MENU until "Select time for delayed start"
displays.
2. In the bottom right corner of the LCD window, a
clockface and a zero will flash. To change the zero,
simply press an Arrow button until the LCD displays
the number of hours you want to delay starting the
program (1–24 hours).
3. If you only want to use this setting temporarily (for
this one load), press START. When the program
ends it will revert back to the previous setting.
4. If you want to save this setting permanently, press
ENTER again then press START. The program will
retain the change.
When you press START, the clockface and the hours
you set for the delay will display, as illustrated below:

Selecting Options

This lets you select Buzzer, Anti-crease, and Normal or
Quick Cooling. Only the options available with the
program you selected will display. (See tables on page
14.)
1. Press MENU until "Select Options" displays.
2. Continue to press MENU to scroll through the options.
3. Press an Arrow button to toggle between Off and On
4. If you only want to use this setting temporarily (for
this one load), press START. When the program
ends it will revert back to the previous setting.
5. If you want to save this setting permanently, press
ENTER again then press START. The program will
retain the change.
REST REST ORING ORING A PRESET A PRESET
REST RESTORING REST ORING ORING A PRESET A PRESET A PRESET
PROGRAM PR PR OGRAM OGRAM OGRAM
PR PR OGRAM
To restore a preset program to its factory default settings,
simply press the button (P1–P4) for the preset program
you want to restore and hold it down while your press
ENTER. The program will revert to its factory default
settings.