Asko T711 Use And Care Manual page 21

CHANGING CHANGING THE LANGU THE LANGU THE LANGUA A A A A GE ON
CHANGING CHANGING CHANGING THE LANGU THE LANGU
THE L THE LCD DISPLA THE L CD DISPLAY Y Y Y Y CD DISPLA CD DISPLA
THE L THE L CD DISPLA
There are eleven languages available for the LCD
window:
English
French
Spanish
Portuguese
Italian
German
To change the language, follow the steps below:
1. Turn the machine off then on again.
ENTER ENTER five times in succession then press ENTER
2. Press ENTER ENTER
P1 five times. (This must be done within 15 seconds.)
3. When the Language menu displays, press an Arrow
button to advance through the menu to the desired
language.
4. Once the correct language displays, press ENTER
to program the LCD window to display the language
you selected.
T761 T761 T761 T761 T761 AND AND T781 ERR AND AND AND T781 ERR T781 ERR T781 ERROR MESSA T781 ERR
Error messages will display in the LCD window if a fault
occurs while a program is in progress. The table below
defines each possible error message. If the message
ERROR MESSAGE
Maximum program time
Overflow (T781)
Sensor
Thermistor
GE ON GE ON
GE ON GE ON
Swedish
Danish
Norwegian
Netherlands
Finnish
OR MESSA OR MESSA OR MESSAGES OR MESSA GES GES GES GES
SOLUTION
Make sure both fuses are intact.
Clean the lint filter.
Make sure exhaust hose is clear (T761).
Clear message by turning the power off then on.
Make sure the condensed water container is empty. If draining into a drain pipe,
make sure the black rubber hose is not kinked or blocked. The drain should not be
higher than 40 inches from the floor.
Make sure the condensation pump is not blocked.
This can appear if there are dry clothes in the drum when the unit is started. Cancel
the error message by opening the door or turning the power off then on.
Call a service technician.
CHILD-SAFE ST CHILD-SAFE ST CHILD-SAFE ST CHILD-SAFE ST CHILD-SAFE STAR
As a safety measure, you can program the T761 and
T781 not to start unless the Start button is held down
for three seconds. To do this, follow the steps below:
1. Turn the machine off then on.
2. Press ENTER five times, then press P3 five times.
(This must be done within 15 seconds.)
3. "Delayed start" displays with "0" flashing in the lower
right corner. Press the Right Arrow button to toggle
the display to "3."
CHILD-SAFE MENU BUTTON
Please note that when you set the child-safe Start button,
the Menu button is automatically programmed to delay
for three seconds before it becomes active. This prevents
a child from accidentally changing the program settings.
When you want to change a program, press the Menu
button for three seconds to activate the menus. The
Menu button will work normally (without the 3-second
delay) until you have completed your changes. If it is
not pressed for two minutes, it will automatically revert
back to the child-safe mode.
still displays after you have checked the possible
solutions, call a service technician.
AR ART T T T T AR AR
Page 21