Selecting Options; Press The Start Button - Asko T754HP Operating Instructions Manual

Tumble drying

Selecting Options

5
By selecting options, you can tailor a
drying program to suit your requirements.
The available options depend on the selected
program. Once you have started the program,
the options you selected are saved for the next
time you use the same program. The exception
is Delayed Start, which is not saved for the next
time.
Energy Save
You can select Energy Save with all programs
except Revitalise and Time dry program.
• Select Energy Save by pressing the button
next to the symbol.
• The lamp next to the button lights when
Energy Save is selected.
Time saver
You can select Time saver with all programs
except Revitalise. The program is shortened by
about 12 minutes.
• Press the button next to the symbol.
• The lamp next to the button lights when Time
saver is selected.
Anti crease
This option means that the drum will rotate for
three seconds per minute for two hours after
the drying program has fi nished. The option
prevents the fabrics from remaining in the
same position and becoming creased, if you
are unable to remove them immediately after
tumble-drying has fi nished. Cannot be selected
with the Air fl uff program.
• Select Anti crease by pressing the button
next to the symbol.
• The lamp next to the button lights when Anti
crease is selected.
12
Delayed Start
Select a program and then press Delayed Start.
Press the button to select a delayed start of 1
to 24 hours. The lamp next to the button lights
when this option is activated. Next press Start
and the machine counts down 1 hour at a time
and starts after the selected delay. To cancel
Delayed Start press and hold Stop for three
seconds. Delayed Start cannot be selected with
Timed dry or Revitalise.

Press the Start button

6
Remaining drying time
An estimate of the remaining drying time
will be shown on the display a few minutes after
the drying program starts. 1:35 means that it will
take approximately 1 hour and 35 minutes for
the load to dry.
The actual remaining time may be longer than
the estimated time shown on the display. The
remaining time is then shown as 0:15 until the
load is suffi ciently dry. If you selected Time
saver the display will show 0:05 instead.
You can stop the tumble dryer by pressing the
Stop button or by opening the door. In both
cases the program is stopped and starts from
the beginning if restarted.
NOTE!
The program will not be aff ected if you change
the program selector after the program has
started.