Table of Contents
Advertisement
TUMBLE DRYING
SELECTING OPTIONS
By selecting options, you can tailor a drying program to
suit your requirements. The available options depend
on the selected program. Once you have started the
program, the options you selected are saved for the
next time you use the same program. The exception is
Delayed Start, which is not saved for the next time.
Temperature Low
You can select Temperature Low with all programs except
Air Fluff .
• Select Temperature Low by pressing the button under
the symbol.
• The symbol lights when Temperature Low is selected.
Buzzer Volume
You can choose to have the machine notify you when a
program has finished or if an error has occurred.
• Select Buzzer Volume by pressing the button under the
symbol.
• The symbol lights when Buzzer Volume is selected.
Time saver
You can select Time saver with all programs except Air
Fluff. The program is shortened by about 12 minutes.
• Press the button under the symbol.
• The symbol lights when Time Saver is selected.
Anti Wrinkle
This option means that the drum will rotate for three
seconds every minute for two hours after the drying
program has finished. If you are unable to remove the
items immediately after the program has finished, this
option prevents the garments from remaining in the same
position and becoming wrinkled. Cannot be selected
with the Air Fluff program. If the Buzzer Volume option
has also been activated, an audible signal will sound
each time the drum rotates as a reminder that the drying
program has finished.
• Select Anti Wrinkle by pressing the button under the
symbol.
• The symbol lights when Anti Wrinkle is selected.
Delayed Start
First select which program you want to use and then
select Delayed Start by pressing the + button. The display
shows Delayed Start in whole hours. Press the + / - button
to select a delayed start of 1 to 24 hours. The symbol for
Delayed Start lights next to the number of hours. Press
the Start button and the machine will count down 1 hour
at a time and start after the selected delay. This option
cannot be used with Timed Dry or Air Fluff .
8
Customer Care Center, 1-800-898-1879, www.askona.com
PRESS THE START BUTTON
Remaining drying time
An estimate of the remaining drying time will be shown on
the display a few minutes after the drying program starts.
1:35 means that it will take approximately 1 hour and 35
minutes for the load to dry. If the Anti Wrinkle option has
been selected, the drum will rotate for three seconds
every minute for two hours after the program is finished.
The actual remaining time may be longer than the
estimated time shown on the display. The remaining time
is then shown as 0:15 until the laundry is sufficiently dry.
If you selected Time saver, the display will show 0:05
instead.
You can stop the tumble dryer by pressing the Stop
button or by opening the door. In both cases the program
is stopped and starts from the beginning if restarted.
NOTE!
The program will not be affected if you change the
program selector after the program has started.
DRYING PROGRAMME FINISHED
The text End appears on the display when the program is
finished. If the Anti Wrinkle option has been selected, the
drum will rotate for three seconds every minute for two
hours after the program is finished.
Backlighting
Two minutes after the drying program finishes the
backlighting on the display and option buttons enters
energy saving mode.
NOTE!
Clean the lint filter in the outer door after each load.
See the Care and maintenance instructions chapter.
WARNING!
If the lint filter becomes clogged, the machine's
automatic overheating cut-out may be triggered. Clean
the filter, wait until the machine has cooled, then try
starting it. If it still does not start: Call the Customer
Care Center.
Once drying has finished
Turn off the main power switch. Remove the clothes and
close the door to prevent small children from climbing into
the machine.
Advertisement
Table of Contents
