Rack-Mounting The Switch - Alcatel-Lucent OMNISWITCH 6800 Hardware User's Manual

Mounting the Switch

Rack-Mounting the Switch

Refer to the important guidelines below before installing the OmniSwitch 6800 Series chassis in a rack.
It is recommended that two people install the switch in the rack—one person to hold the chassis and
•
position it in the rack, and a second person to secure the chassis to the rack using attachment screws
(not supplied).
Alcatel-Lucent provides two rack-mount flanges with each OmniSwitch 6800 Series switch. These
•
flanges support standard 19-inch rack mount installations. These flanges must be attached to the chas-
sis before the switch can be rack mounted.
Note. If you are installing the switch in a 23-inch wide rack, Alcatel-Lucent offers optional 23-inch rack-
mounting hardware. For more information, contact your Alcatel-Lucent representative.
Alcatel-Lucent does not provide rack-mount screws. Use the screws supplied by the rack vendor.
•
To prevent a rack from becoming top heavy, it is recommended that you install heavier equipment at
•
the bottom of the rack whenever possible.
If you are installing the switch in a relay rack, be sure to install and secure the rack per the rack
•
manufacturer's specifications.
Review page 2-16
•
Rack Mounting Steps
To rack-mount the switch, follow the steps below:
1
Align the holes in the provided rack-mount flanges with the four threaded holes in the OmniSwitch
6800 Series chassis. These threaded holes are located in the left and right sides of the chassis, near the
front panel.
2 Attach the flanges to the chassis using the provided Phillips-head screws. Be sure to tighten each of the
screws firmly using a Phillips screwdriver.
page 2-20
for important chassis airflow and access recommendations before installing.
Attaching a Rack-Mount Flange
OmniSwitch 6800 Series Chassis and Hardware Components
P R I
B P S
O K
P
T M
R
P W
F A N
OmniSwitch 6800 Series Hardware Users Guide June 2007