Reloading The Secondary Management Module - Alcatel-Lucent OMNISWITCH 6800 Hardware User's Manual

Managing OmniSwitch 6800 Series Stacks

Reloading the Secondary Management Module

If the switch with secondary management role is reloaded, the idle switch with the lowest slot number will
automatically assume the secondary role. The reloaded switch (the former secondary) will assume an idle
role when it comes back up.
Meanwhile, the switch with the primary management role, as well as any other idle modules in the stack,
continue operations without interruption.
To reload the secondary management module, use the
secondary in the command line. For example:
-> reload secondary
Note. A secondary management module reload can also be scheduled for a later time or date. For informa-
tion on scheduling a secondary module reload, as well as additional command details, refer to the
OmniSwitch CLI Reference Guide.
Primary - Slot 1
Secondary - Slot 2
Idle - Slot 3
Idle - Slot 4
-> reload secondary
Primary - Slot 1
Booting...
Secondary - Slot 3
Idle - Slot 4
Primary - Slot 1
Idle - Slot 2
Secondary - Slot 3
Idle - Slot 4
Reloading the Secondary Management Module In a Stack of Three or More
OmniSwitch 6800 Series Hardware Users Guide
reload command. Be sure to include the syntax
In this stack of four OmniSwitch 6800 Series switches, the slot 1
1
switch is the primary management module. The slot 2 switch is
the secondary. Slots 3 and 4 are operating in idle roles.
The user reloads the stack's secondary management module by
2
issuing the reload secondary command. Any data flow on the
secondary switch's Ethernet ports is interrupted.
The idle switch with the lowest slot number—in this case,
3
slot 3—automatically becomes the secondary management
module. The slot 4 switch remains unaffected. In addition,
Ethernet traffic on slots 1, 3, and 4 remains unaffected.
When the rebooted switch comes back up, it assumes an idle role
4
within the stack.
June 2007
Reloading Switches
page 3-27