Restoring Factory Default Settings - Garmin AIS 300 Technical Reference

Technical reference for garmin nmea 2000 products

Hide thumbs Also See for AIS 300:

Installation instructions manual (8 pages)

Declaration of conformity (6 pages)

Installation instructions manual (8 pages)

Table Of Contents

Table of Contents

Location

TEMPSOURCE Value

Water

Air outside

Air inside

Engine room

Main cabin

To configure the temperature offset if the menu option is not displayed:

If the temperature data displayed on the gauge connected to the GST 10 adapter is not the same as temperature data displayed on other devices,

you can configure the temperature offset to increase or decrease the displayed temperature by a specific amount.

1. From the NMEA 2000 Devices list, select the GST 10 device.

2. Select an option:

•

For most Garmin chartplotters, select

•

For other Garmin marine devices, select

3. Enter the following command: "TEMPOFFSET="

4. After the command, enter a positive or negative decimal number, followed by Done.

For example, TEMPOFFSET=-2.5Done indicates that the temperature readings displayed on the gauge connected to the GST 10 adapter

will be decreased by 2.5 degrees Celsius.

To configure the sensor number if the menu option is not displayed:

If multiple GST 10 adapters are assigned to the same NMEA 2000 temperature source, each adapter is assigned a unique sensor number

automatically. If the "Invalid NMEA 2000 temperature configuration" error message appears, you must assign a unique sensor number to each

adapter.

For example, if two adapters are assigned the NMEA 2000 temperature source value of Live Well and the error message appears, you must

assign each adapter a unique number.

1. From the NMEA 2000 Devices list, select one of the GST 10 devices assigned to the same temperature source.

2. Select an option:

•

For most Garmin chartplotters, select

•

For other Garmin marine devices, select

3. Enter the following command: "INSTANCE="

4. After the command, enter a positive decimal number, followed by Done.

5. Repeat steps 1–4 for each GST 10 device assigned to the same temperature source.

For example, if two GST 10 adapters are assigned the value of Live Well, assigning INSTANCE=1 to the first adapter and assigning

INSTANCE=2 to the second adapter prevents the error message.