Table of Contents
Advertisement
PRO-DP16 Pushbuttons and LEDs (Cont.)
Pushbuttons (1-16 Cont.):
16 (Mode)
LEDs:
Program (PGM)
Pack (PCK)
Curve (CRV)
Low-end (LE)
Channel LEDs (1-6)
The first time PROlink is wired to a PRO-DP16 panel, each LED on the panel lights in sequence,
starting with LED 1 and ending with the last Mode LED. Recycling power to the panel resets the
PRO-DP16 to its default setting (Channel 1 LED lights and is active).
Presets, Channels, and Zones
A Preset is a set of instructions used for the recall of a stored scene (a group of lighting levels). A
group of lighting levels is also known as a zone. The PRO-DP16 uses channels to control zones.
Each channel represents a controlled lighting zone. Preset fade time is the amount of time it takes to
fade from one Preset light level to the next. A zone's light level is the intensity of light produced
between the On/Off states.
When a Preset is selected, the active zone/channel moves to the specific light scene stored in
memory for that Preset. Lights associated with a particular zone/channel fade from one Preset to the
next based on the length of time specified for the fade intervals, in 1-second intervals (default = 3
seconds). In default mode, the PRO-DP16 can select and change Presets 1-10, and Off. Via the rear
panel DIP switch, the PRO-DP16 can be set to select and change Presets 1-16. Refer to the Using
Switch 7 to Enable Either Preset Recall mode, or Up/Down Ramping section on page 17 for details.
A PRO-DP16 has a specific value associated to each Preset button on the panel. For installations
where multiple PRO-DP16 panels are used to share control of a single Pack, you can set identical
Presets on more than one panel. Multiple panels that share all or some of the same presets can be
used to perform identical functions on a particular pack.
For installations with multiple panels controlling multiple Packs, there can't be any overlapping in
Preset assignments; therefore, by offsetting the values for the individual buttons on different panels
PRO-DP16 Decor 16-Button PROlink Wall Panel
Cycles through the four Program modes:
• Program - Allows you to program presets.
• Pack - Allows you to program pack assignments on the panel.
• Curve - Allows you to program dimming curves on the panel.
• Low-end - Allows you to program low-end settings on the panel.
The panel must be in Program mode before the Pack, Curve or Low-end modes
can be selected.
Lights when the panel is Program mode, allowing you to program presets. To
enter Program mode, press the up and down arrow buttons (14 and 15) simulta-
neously until the PGM LED lights.
Lights when the panel is Pack mode, allowing you to program pack assignments
on the panel. To enter Pack mode, press the up and down arrow buttons (14 and
15) simultaneously until the PGM LED lights, then press the Mode button (16) to
light the PCK LED.
Lights when the panel is Curve mode, allowing you to program dimming curves
on the panel. To enter Curve mode, press the up and down arrow buttons (14 and
15) simultaneously until the PGM LED lights, then press the Mode button (16)
twice to light the CRV LED.
Lights when the panel is Low-end mode, allowing you to program low-end set-
tings on the panel. To enter Low-end mode, press the up and down arrow button
simultaneously until the PGM LED lights, then press the Mode button (16) three
times to light the LE LED.
Light to show the channel/zone (1-6) that is currently selected.
Product Information
3
Advertisement
Table of Contents
