Table of Contents
Advertisement
Panel Programming/Operation
7. The panel automatically exits Low-End mode.
Panel Operation
The following sub-sections describe using the panel to recall, adjust, and ramp programmed
presets. These instructions assume that the panel has already been programmed.
Recalling a programmed Preset
To recall a programmed Preset, simply press the Preset button associated with the Preset. The LED
next to the selected button lights to indicate the active Preset.
!
!
For more information on Preset Recall and Default modes for the panel, refer to the DIP Switch
Configuration section on page 15.
Ramping Presets
Ramping a Preset involves either raising or lowering a light level on an active Preset. DIP switch 7
determines if the panel has the ability to raise or lower channel levels.
!
!
To raise and lower the light level for Preset in a selected zone (0-100%):
1. Press Select until the desired channel/zone LED is active (indicated by the channel LED).
2. Press and hold the Preset for approximately 2 seconds to activate the desired lighting level that
you want to ramp.
3. Press the Up/Down buttons (pushbuttons 14 and 15) to raise or lower the light level for the
selected channel/zone.
4. Continue selecting zones and repeat steps 1 through 3 as many times as needed.
24
If the panel is in Preset Recall mode (DIP switch 7 set to On), any pushbutton (1-16) can
recall a Preset.
If the panel is in Default mode (DIP switch 7 set to Off), pushbuttons 1-10 can recall
Presets. In Default mode, the Select (pushbutton 13), and Up/Down (pushbuttons 14 and
15) buttons do not recall Presets, and Off (pushbutton 12) recalls the Off Preset.
If switch 7 is in default mode (Off), pushbuttons 14 and 15 function as Up and Down
buttons for ramping presets.
If switch 7 is On, channel ramping is disabled, and pushbuttons 14 and 15 recall Presets
(instead of ramping channels).
PRO-DP16 Decor 16-Button PROlink Wall Panel
Advertisement
Table of Contents
