Table of Contents
Advertisement
Panel Programming/Operation
Setting levels
1. Select the Pack you want to set levels on.
2. Select the Channel that you want to set levels on.
3. Use the UP and Down buttons (pushbuttons 14 and 15) to raise/lower the light level for the
selected Pack/Channel.
4. Repeat the preceding steps as required for other Channels, per Pack.
Raising and lowering levels
1. Select the Pack and Channel you want to set levels on.
2. Press the Up button (pushbutton 14) to raise the dimming level at the default ramping speed.
Dimmers stop ramping when the button is released, or when the dimmer reaches its full-on
level.
3. Press the Down button (pushbutton 14) to lower the dimming level at the default ramping
speed. Dimmers stop ramping when the button is released, or when the dimmer reaches its full-
off level.
4. Dimmers stop ramping when the button is released, or when the dimmer reaches its full-on
level.
5. Repeat the preceding steps as required for other Channels, per Pack.
Curve Select Mode
The panel must be in Curve Select mode in order to set dimmer curves. To enter Curve Select
mode:
1. Enter Program mode (indicated by the PGM LED).
2. Press Mode (pushbutton 16) twice.
3. Curve Select mode is indicated by the CRV LED.
Setting a dimmer curve
The PRO-DP16 has the ability to choose from 17 different dimming curves available for use within
a Radia Lighting system. A curve can be used to govern the amount of dimming control relative to
the level setting allowing for uniform dimming between different loads. These curve plots are to be
used as a relative guide to determining optimum performance. Actual field performance and
measurements will be similar but not equal.
Note the Pack number set on the SW2 DIP switch for the desired dimmer Pack you will be working
with. See the Assigning Pack numbers on the dimmer control cards section on page 7 for details.
1. Select the Pack you want to set a dimmer curve on.
2. Select the Channel that you want to set the curve on. Press Select (pushbutton 13) to cycle to
the desired Channel (1-6), indicated by pushbutton LEDs 1-6. Channel selection cycles
through Channels 1-6, then repeats.
3. Enter Curve Select Mode (indicated by the CRV LED).
4. Choose the desired curve number, based on the curves described in the following table. Use the
"10" key for "0" in 2-digit curve numbers.
22
PRO-DP16 Decor 16-Button PROlink Wall Panel
Advertisement
Table of Contents
