Setting And Changing Fade Times; Clearing (Undefining) Presets; Pack Select Mode; Selecting A Pack - AMX PRO-DP16 DECOR PROLINK FLUSH MOUNT KEYPAD PANEL Instruction Manual

Setting and changing fade times

1. Press the Preset button where the new ramp time will be stored.
2. Enter Program mode (indicated by the PGM LED).
3. Set the fade time by pressing and holding a Preset button for the amount of time you want the
fade to occur (the fade is from a currently active Preset level to the next active level). The new
fade time is recorded when the button is released.
4. Wait 8 seconds for the new fade setting to be associated with the Preset (do not touch any
buttons at this time).
5. Repeat the preceding steps as required for other Presets.

Clearing (undefining) Presets

To clear an individual channel of its presets:
1. Enter Program mode (indicated by the PGM LED).
2. Press the Preset button that you want to clear the recorded presets.
3. Press Clear (pushbutton 11) to return the selected Preset to an undefined state.
To clear all channels of their recorded presets.
1. Enter Program mode (indicated by the PGM LED).
2. Press Select (pushbutton 13) once.

Pack Select Mode

The panel must be in Pack Select mode in order to set levels for the packs. To enter Pack Select
mode:
1. Enter Program mode (indicated by the PGM LED).
2. Press Mode (pushbutton 16) once.
3. Pack Select mode is indicated by the PCK LED.

Selecting a Pack

1. Enter Pack Select mode (indicated by the PCK LED).
2. Use pushbuttons 1-10 to select the Pack (1-10) that you want to address.
3. The panel automatically exits Pack Select mode when the pushbutton is released.

Selecting a channel

1. Select the Pack containing the channel(s) you want to address.
2. Press Select (pushbutton 13) to cycle to the desired Channel (1-6), indicated by pushbutton
LEDs 1-6. Channel selection cycles through Channels 1-6, then repeats.
PRO-DP16 Decor 16-Button PROlink Wall Panel
Panel Programming/Operation
21