Editing Device Notification Settings - AMX NETLINX STUDIO V2.4 Instruction Manual

Working With Online Devices
5. Click OK to close the NetLinx Notification Properties (Add) dialog and return to the NetLinx
Device Notifications Options dialog. The new target device specified has its own line in the
notifications list. The Device:Port:System values (for example, 1:0:0) identify the device in the
Device column. The selected notification option(s) are labeled as ON in the associated
column(s).
6. Repeat steps 2-5 to configure NetLinx Notifications for as many additional devices as is
necessary.
A very large amount of data may be generated if all options are enabled for every
device in a large System.
Select Enable Asynchronous Notifications to enable/disable NetLinx asynchronous
notification messages being sent by the master controller. These are low-level strings of raw
data, used primarily for troubleshooting the NetLinx master. This option is intended for use in
conjunction with AMX Technical Support.
7. Click Done to save the changes and exit the NetLinx Device Notifications Options dialog.

Editing Device Notification Settings

In order to edit, add or remove devices from the list you must be connected to a NetLinx master
controller.
1. Select Diagnostics > NetLinx Device Notification Options to open the NetLinx Device
Notifications dialog.
2. Select a device in the Device list and click the Edit button to open the NetLinx Notification
Properties - (Edit) dialog. Alternatively, you can double-click on a device in the Device list to
access this dialog.
3. Check or un-check the notification types as desired. Note that the target device's Device, Port
and System settings are read-only. This option allows you change the selected device's
notification options only.
A very large amount of data may be generated if all options are enabled for every
device in a large System.
4. Click OK to save your changes and return to the NetLinx Device Notifications Options dialog.
The new notification options are indicated (as ON) in the notifications list.
Select Enable Asynchronous Notifications to enable/disable NetLinx asynchronous
notification messages being sent by the master controller. These are low-level strings of raw
data, used primarily for troubleshooting the NetLinx master. This option is intended for use in
conjunction with AMX Technical Support.
122
To set the selected set of notifications as the default notifications for this device, click the
Set As Defaults button.
Once you set the default notifications, you can use the Use Defaults button to recall the
default set.
NetLinx Studio (v2.4 or higher)