Configuring Device Connection Communications Settings - AMX IREDIT V1.2 Instruction Manual

Basic Operations
3. After you have all the necessary information listed, click Start. You will then see a status bar.
4. Once it is done sending you can select Close. The status will read "Disconnecting".

Configuring Device Connection Communications Settings

Use the options in the Communications Settings dialog to specify communication settings for
transfer operations.
FIG. 17 Device Connection Communications Settings Dialog
1. Select Tools > Comm Settings... to open the Communications Settings dialog.
2. Choose the Platform Selection. Select between NetLinx Master and Axcess Master by
clicking on the radio button.
Depending on your selection, Transport Connection Option will change to reflect
the Master selected.
3. Choose the Transport Connection Option. Select between TCP/IP, Serial, Modem and
Virtual NetLinx Master.
4. After you have selected the connection type you must arrange the configuration in Settings.
If your NetLinx Master has Authentication Required enabled, you need to do the following:
1. Place a check in the box next to Authentication Required.
2. Click the button UserName and Password to launch the corresponding dialog window.
3. Enter the username and password associated with the targeted Master and click OK.
4. Select OK to save changes and close the Communications Settings dialog.
24 IREdit