Pt10 And Pt15 Camera/Lens Mounting And Balancing - AMX AXB-PT101530 POSITRACK CAMERA CONTROLLER Instruction Manual

Installation
Position marker
(on the outer surface)
Ø 3.453"
87.7 mm
FIG. 12 Tilt Hub (Mounting plate) dimensions
Each PosiTrack unit can be mounted to camera mounts such as the TM-CAM, WM-CAM, and
PM-CAM as shown in FIG. 13.
Wire
tie-mount
FIG. 13 Pedestal mount
The camera/lens cradle can be mounted on either side of the cradle support bracket.

PT10 and PT15 Camera/Lens Mounting and Balancing

The camera/lens assembly should be mounted so the tilt axis is capable of going through the optical
axis of the camera, assuming the optical centerline is between 1/2" (12.70 mm) and 5" (127.00 mm)
above the mounting plane of the camera lens. The mounting platform (camera cradle) allows the
camera/lens to be mounted with its center of gravity on the tilt axis. The maximum weight of the
camera/lens assemblies on the PT10 is 10 lbs. (4.54 kg) and on the PT15 is 15 lbs. (6.80 kg). The
camera cradle is mounted to the Tilt Hub (FIG. 14).
16
Camera points this way when the pan drive is in
the center of its range of motion (Home position)
3.00 BHC"
76.20 mm
AXB-PT10/15/30 PosiTrack Camera Controllers
3.45"
(87.7mm)
Cradle support bracket
Camera mount assembly
PM-CAM (Pedestal mount)