Table of Contents
Advertisement
FIG. 7 Control panel removal for PT10 and PT15
6. Carefully pull the cover straight up from the main unit, until the bottom edge of the cover
clears the connector panel and then slide it backwards (as seen in FIG. 8).
FIG. 8 Removing cover on the PT10 and PT15
Accessing the AXB-PT30 Internal Jumpers
Jumpers J6 - J8, located on the circuit board inside the AXB-PT30, set the communication mode to
AXlink (factory default) or RS-232.
You need a 5/64" (1.98 mm) and 1/16" (1.59 mm) Allen wrench to open the unit, and a pair of non-
conducting pliers to set the jumpers using the following steps.
1. Discharge any accumulated static electricity from your body before removing the enclosure.
Remove the static electricity by touching a grounded metal object.
2. Unplug all connectors from the rear panel of the AXB-PT30.
3. Using the 1/16" Allen wrench, remove the four #4-40 socket head screws located around the
connector panel (FIG. 9), by using.
4. Remove the 16 BHSC screws, using the 5/64" Allen wrench, from the left, right, top, and back
sides of the AXB-PT30. A sample view of the screw locations is shown in FIG. 9.
5. Carefully pull the cover straight up from the main unit, until the bottom edge of the cover
clears the connector panel, and place the cover aside (see FIG. 8).
AXB-PT10/15/30 PosiTrack Camera Controllers
Pre-Installation
Pins that connect
the control panel
to the motherboard
11
Advertisement
Table of Contents
