Setting The Internal Jumper Communication Mode - AMX AXB-PT101530 POSITRACK CAMERA CONTROLLER Instruction Manual

Pre-Installation
Connector panel
(four screws)
BHSC screws
(two on the rear)
FIG. 9 Pan-head screw locations

Setting the Internal Jumper Communication Mode

1. Locate jumpers J6, J7, and J8 communication mode jumpers on the Mother PCB (FIG. 10).
The connectors and the main board are mounted onto the pan base.
2. Set the jumpers for either AXlink or RS-232 communication.
FIG. 10 Communication mode jumpers J6, J7, and J8 (factory default set to AXlink)
3. Set the jumpers for either AXlink or RS-232 communication.
Jumper Settings (top view)
AXlink (pins 1 & 2)
Jumper 8
Jumper 7
Jumper 6
Pin #s 1 2 3
12
PosiTrack 30
LENS POWER
AMX
Jumper
locations
J8
(3 pair)
J6
Lens control
section
RS-232 (pins 2 & 3)
Jumper 8
MOTOR
Jumper 7
Jumper 6
RS-232
LENS
CAM
AXlink
J6, J7, and J8
communication
mode settings
MOTOR
Pin #s 1 2 3
AXB-PT10/15/30 PosiTrack Camera Controllers
BHSC screws
(two screws on top)
BHSC screws
(six screws on
each side)