Cisco BBSM 1 User Manual page 26

Configuring Windows for Multinet
Click Submit. A confirmation window appears.
Step 7
Click Close.
Step 8
Configuring Windows for Multinet
This section describes how to configure the Windows operating system to support multiple networks
(multinets), on the BBSM Hotspot server. You only need to perform this procedure if you are using a
multinet. BBSM Hotspot servers are initially configured as single networks, or singlenets.
For more information on multinets, refer to the
Note
page
Although you use the Network and Dial-up Connections window to add multinet 2, do not delete
Caution
multinet 2 through this window, because although it is deleted from the GUI, it does not actually get
removed from the BBSM Hotspot databases. Use the Address Change Wizard to remove multinet 2.
Refer to the
Use the following procedure to reconfigure the internal NIC on your BBSM Hotspot server.
Right-click My Network Places.
Step 1
From the pop-up menu, select Properties. The Network and Dial-up Connections window appears.
Step 2
(See
Figure 2-26 Network and Dial-up Connections Window
Right-click AtNatMP, and select Properties. The AtNatMP Properties window appears.
Step 3
(See
Cisco BBSM Hotspot 1.0 User Guide
2-26
2-40.
"Running the Address Change Wizard" section on page
Figure 2-26.)
Figure 2-27.)
Chapter 2
"Private and Public IP Addresses (Multinet)" section on
A-1.
Setting Up BBSM Hotspot
78-15293-01