Advertisement
Running the Setup Wizard
Figure 2-10 Enter Network Device Configuration Parameters Window
Enter the network device parameters, as described in
Step 12
the number of IP addresses to allocate to the network device range. (This may have been familiar to
current BBSM customers as the "Management Range.") This information will also be used in the switch
discovery part of the wizard.
Table 2-5
Field
Number of Network Devices
SNMP Password
Step 13
Click Next. The Calculating Internal Network Address Ranges window appears, providing you with a
list of the internal IP address ranges that have been calculated and assigned by the BBSM Hotspot server.
These include the following:
Network Device Addresses—These addresses are allocated to the network devices. This address
•
range is allocated from the "Number of Network Devices" number entered in
Cisco BBSM Hotspot 1.0 User Guide
2-12
Enter Network Device Configuration Descriptions
Description
Enter the total number of switches and wireless access points that will
be installed on the BBSM internal network. You can also enter a larger
number than the current amount of network devices in anticipation of
additional devices in the future.
Enter the SNMP password that is used to access network devices.
BBSM Hotspot needs this information to run switch discovery. Note
that on Cisco Catalyst switches, the SNMP password is also known as
the SNMP community read/write string.
Chapter 2
Table
2-5. The wizard uses this data to determine
Setting Up BBSM Hotspot
Step
12.
78-15293-01
Advertisement
