Advertisement
Chapter 2
Setting Up BBSM Hotspot
Caution
DHCP Client Addresses—These addresses are allocated to the DHCP client address pool. Because
•
most network devices are configured as DHCP, after the BBSM NIC and the network device
addresses have been allocated, BBSM Hotspot allocates 90 percent of the available end-user
addresses to the DHCP pool. You can modify this address range in the Hotspot Configuration tool
on the Dashboard or by using the Address Change Wizard.
Static Client Addresses—These addresses are allocated to the statically configured client address
•
pool. Because static configurations are not common, this range is allocated by BBSM Hotspot to
10 percent of the total remaining pool after the BBSM NIC and the Network Device addresses have
been allocated.
(See
Figure
Figure 2-11 Calculating Internal Network Address Ranges Window
Click Next. The Discovering Network Devices window appears, showing that BBSM Hotspot is running
Step 14
switch discovery to find network devices connected to the BBSM Hotspot internal network.
(See
Figure
with the device. The progress bar shows the number of devices found based on the number entered in
Step
12. The Back and Next buttons are disabled until the process is complete.
78-15293-01
The IP addresses of your switches and access points must be set to addresses that are within
this Network Devices Address range. To increase performance, we recommend using the
numbers in this range consecutively so that any unused IP addresses are at the end of the
range.
2-11.)
2-12.) As each device is discovered, BBSM Hotspot is automatically configured to work
Running the Setup Wizard
Cisco BBSM Hotspot 1.0 User Guide
2-13
Advertisement
