Connection Of The Loudspeakers - VINCENT SP-T800 Instructions For Use Manual

CONNECTION OF THE POWER CABLE
Check that the electricity supply to your home is appropriate to the device. The required voltage and fre-
quency can be read on the back of the device beside the socket for the mains. If the electricity supply is
appropriate, push the inlet connector of the supplied mains cable firmly into socket for the mains on the
back of the device (6). Connect the other end of the mains cable to a mains socket.

CONNECTION OF THE LOUDSPEAKERS

Either a single speaker (A) or two speakers (A+B) can be connected to this amplifier. Both outputs are iden-
tically provided with the input mono signal. For each loudspeaker you will find two connector screws (posi-
tive + und negative -) at the amplifier's backside. One side of the speaker cable must be attached here. At
the loudspeaker connection terminal there are similar connector screws or connectors. There, the polarity of
each screw (+ or -) can be identified as well and the other side of the speaker cable associated with this
speaker must be attached. Make sure only connector screws of the same polarity will be connected by each
speaker cable wire: a knob marked "+" in the amplifier's terminal must be connected with a speaker's con-
nector screw marked "+" as well.
SP-T800
If every speaker is connected in a conventional way (a two core speaker cable for each loudspeaker) and
you own loudspeakers that are equipped with Bi-Wiring terminals (four connector screws) you have to
make sure that the metal brackets (contact pieces consisting of small metal plates or short pieces of cable
which are supplied with the speakers) are applied to the terminal and that each one connects the two
knobs of the same polarity (e.g. both connectors marked "+"). The connector screw labelled "+" and "A"
at the amplifier's backside must be connected to one of the bridged, labelled "+" connectors of the loud-
speaker. Accordingly, the connector screw labelled "-" and "A" at the amplifier's backside must be con-
nected to one of the bridged, labelled "-" connectors of the loudspeaker. Additionally, the speaker con-
nectors "A" must be activated at the front panel button "SPEAKER A" (2).
If a second loudspeaker is to be connected, then the clamps of the output "B" are connected in a similar
fashion to the additional loudspeaker. This loudspeaker is activated by switching on the "SPEAKER B" but-
ton (2) on the front of the unit. However, this is only permitted if both loudspeakers have a nominal impe-
dance of at least 8Ω!
Vincent
26
Loudspeaker cable
Loudspeaker