Connecting The Preamplifier - VINCENT SP-T800 Instructions For Use Manual

This main amplifier is equipped with a mono audio input ("LINE IN") on which the unit awaits the preampli-
fied signal of an audio channel (for example "PRE OUT R" or "Front R"). This is the audio information that
the SP-T800 provides for one or two loudspeakers.
Please note:
No source with a standard line level signal ("LINE OUT") must be connected to this input. It is only
intended for preamplified signals (e.g. "PRE OUT").
This audio input is equipped with two connectors with which the preamplifier can be connected as desi-
red by means of either the RCA or XLR connection on the SP-T800. If your preamplifier offers both opti-
ons, XLR is preferable. Only one of the two connectors may be used at any given time. The setting of the
switch "XLR/RCA" determines which connector is currently used as the input. If the preamplifier is connec-
ted with an RCA cable, then the setting "RCA" should be chosen. If the preamplifier is connected with an
XLR cable, then the setting "XLR" is the correct one. The selected audio input connector must be intercon-
nected to the output connector ("PRE OUTPUT" or "OUTPUT") of a preamplifier. If the SP-T800 is to sup-
ply one channel of a stereo system, connect the input connector of the SP-T800 with a preamplifier output
socket that is usually labelled "PRE OUT R" or "PRE OUT L".
SP-T800
SP-T800
If the SP-T800 is used in a multi-channel system, then the connection socket of the desired channel in the
connection field of the decoder preamplifier usually marked with "AUDIO OUTPUT" is to be connected to
the input of this main amplifier.
Vincent
24

CONNECTING THE PREAMPLIFIER

RCA connection
XLR connection
1 2 BALANCE
OUTPUT
1 2 BALANCE
OUTPUT
stereo preamplifier
stereo preamplifier