Installation; Rear View - VINCENT SA-31 - ANNEXE 588 Instructions For Use Manual

REAR VIEW

9 10
9. INPUT: Terminal for stereo audio signals
of the source equipment
Here you find four stereo RCA input sockets for
source equipment with analogue stereo (line level)
audio output.
10. REC OUT: Output connectors assigned to
a recording device
If desired, you can connect a recording device
like a CD recorder or a tape recorder to this out-
put. The stereo signal of this output is identical to
the output signal of the selected audio source at
one of the preamplifier inputs.
22 Vincent
11 12
11. OUTPUT: preamplifier outputs
With these two pairs of connectors you can con-
nect the preamplified stereo audio signal of the
currently selected source to the power amplifier
channels.
12. FUSE: Fuse holder
This small plastic housing holds the fuse. Refer to
the security precautions.
13. AC: Power Connector
To establish the power supply, connect the plugs
of the power cable to the device and to a suitab-
le wall outlet.
Set up the cable links in a sequence as follows. Connect the power cable between device
and power supply only after all other connections have been made.
Protective caps
Prior to the first installation the pro-
tective plastic caps must be removed
from all the connections used at the
rear of the unit.
13
RCA connections
Mechanically identical RCA plugs are available for
analogue and digital outputs. Make sure that you
do not get these connections confused during

installation!

Make sure that you do not mix up the analogue con-
nectors for right and left. The RCA plugs for these are
mostly colour coded as follows: red for the right chan-
nel, black or white for the left channel.
Contacting the middle pin of the RCA plugs with the
outer ring of the RCA chassis jack may lead to dama-
ges to the main amplifier if it is switched on! To avoid
this hazard, connect or disconnect only in switched-off
state and more than one minute after deactivating!
INSTALLATION
DURING INSTALLATION PLEASE OBSERVE
THE FOLLOWING ADVICE:
Cable connections
1 2
Make sure that all plugs fit tightly. Inadequate con-
nections can cause noise interference, failures and
malfunctions.
OUTP UT OU
- wrong -
To make the most of the components' sound poten-
tial, only high quality loudspeakers and connecting
cables, for example Vincent cables, should be
used. Your local stockist will be glad to advise you
about this.
- correct -
Vincent 23