Connecting The Power Supply - TYAN TIGER 133 Manual

Chapter 2
Board Installation

8. Connecting the Power Supply

Tyan recommends using an ATX power supply that conforms to industry
standard revision 2.01. The Tiger 133 motherboard comes equipped with one
onboard power connector. Figure 2-16 below shows an ATX power connector.
When plugging in the power connector, make sure that the plastic clip on the
power connector is aligned with the plastic tab on the onboard connector
(see Figure 2-17 below). Make certain that you do not miss any
pins because if you do, you will void your warranty and cause damage to
yourself or your motherboard when you turn the system on. After connecting
the power, make sure the connector is seated firmly into its socket so it will not
become loose or fall off when the computer is jostled or moved.
Figure 2-16
*Note: The image above is used to illustrate a concept and may not represent the actual
image of your motherboard.
You are done!
Other than checking the jumper settings and cable connections and putting the
case back on, you are done. Installing a new motherboard may sound difficult,
but by following these directions, you should have a fairly uneventful time
installing our products. If you do encounter problems, your dealer will be able to
help you, or you can consult one of our many technical support resources (see
page 8).
Figure 2-17*
28
http://www.tyan.com